Proper packing of red reflector, charger and tool kit:
1. Above is a picture of the piece of Styrofoam that goes on top
of the back of the scooter when the scooter gets packed into the
2. The inspector should check a few scooters from each shipment
to make sure each scooter contains: 1 rear red reflector, 1 tool
kit, 1 charger with a USA type plug on it and a 2 prong charger
socket on the other end.
3. It is very important that the inspector makes sure to check a
few of the scooters as they are packed to make sure the factory
does not use 3 prong charger sockets on our chargers. All sockets
must be 2 prongs only. This is very important.
4. A piece of clear tape should keep the 3 parts inside the Styrofoam
during shipping. Please make sure they tape them inside the Styrofoam.